Netgear FWG114P v2 User Manual

Virtual Private Networking

8-15

There are a variety of configurations you might implement with the FWG114P v2. The scenarios 
listed below illustrate typical configurations you might use in your organization.

In order to help make it easier to set up an IPsec system, the following two scenarios are provided. 
These scenarios were developed by the VPN Consortium (

). The goal is to 

make it easier to get the systems from different vendors to interoperate. NETGEAR is providing 
you with both of these scenarios in the following two formats:

•

VPN Consortium Scenarios without Any Product Implementation Details as presented in 

 and 

.

•

VPN Consortium Scenarios Based on the FWG114P v2 User Interface as presented in 

 

 and 

.

The purpose of providing these two versions of the same scenarios is to help you determine where 
the two vendors use different vocabulary. Seeing the examples presented in these different ways 
will reveal how systems from different vendors do the same thing.

Follow this procedure to configure a VPN tunnel using the VPN Wizard. 

Note: The LAN IP address ranges of each VPN endpoint must be different. The connection will 
fail if both are using the NETGEAR default address range of 192.168.0.x. 

1.

Log in to the FVS318 on LAN A at its default LAN address of 

 with its 

default user name of 

 and password of 

. Click the VPN Wizard link in the 

main menu to display this screen. Click Next to proceed.

Note: If you have turned NAT off, before configuring VPN IPSec tunnels you must first 
open UDP port 500 for inbound traffic as explained in