Netgear FWG114P v2 User Manual

Connecting the FWG114P v2 to the Internet

3-15

1.

Enter your assigned IP Address, Subnet Mask, and the IP Address of your ISP’s gateway 
router. This information should have been provided to you by your ISP. You will need the 
configuration parameters from your ISP you recorded in “Record Your Internet Connection 
Information” on page 3.

2.

Enter the IP address of your ISP’s Primary DNS Server. If a Secondary DNS Server address is 
available, enter it also.

Note:  DNS servers are required to perform the function of translating an Internet name, such 
as www.netgear.com to a numeric IP address. For a fixed IP address configuration, you must 
obtain DNS server addresses from your ISP and enter them manually here. You should reboot 
your PCs after configuring the firewall for these settings to take effect.

3.

Click Apply to save the settings.

4.

Click Test to test your Internet connection. If the NETGEAR Web site does not appear within 
one minute, refer to 

Use the procedure below to configure an Internet connection via the serial port of your firewall.

There are three steps to configuring the serial port of your firewall for an Internet connection:

1.

Connect the firewall to your ISDN or dial-up analog modem.

2.

Configure the firewall.

3.

Connect to the Internet.

Follow the steps below to configure a serial port Internet connection on your firewall.

1.

a.

Turn off your modem and connect the cable from the serial port of the FWG114P v2 to the 
modem.

b.

Turn on the modem and wait about 30 seconds for the lights to stop blinking. 

2.

Configure the Serial Port of the Firewall.

a.

Use a browser to log in to the firewall at http://192.168.0.1 with its default User Name of 

 and default Password of 

, or using whatever Password you have set up.

b.

From the Setup Basic Settings menu, click Serial Port.