HP (Hewlett-Packard) T1200 User Manual
The printer displays out of paper when paper is available
If the roll has become loose from its core, it will not feed correctly and the printer will not load the
paper. If possible, tighten the paper to its core or load a new roll.
paper. If possible, tighten the paper to its core or load a new roll.
Prints do not fall neatly into the basket
●
Ensure the basket is correctly installed.
●
Ensure the basket is open.
●
Ensure the basket not full.
●
Paper often tends to curl near the end of a roll, which can cause output problems. Load a new
roll, or remove prints manually as they are completed.
roll, or remove prints manually as they are completed.
The sheet stays in the printer when the print has been
completed
The printer holds the paper to allow the print to dry after printing, see
. If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the
Form feed and cut
key
on the front panel, see
.
The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see
. You can disable the cutter, see
The cutter does not cut well
By default the printer is set to automatically cut the paper after the drying time has been completed.
If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any
obstacles.
obstacles.
The roll is loose on the spindle
The roll may need to be replaced or reloaded.
144 Chapter 15 Troubleshooting paper issues
ENWW
Paper issu
es