HP (Hewlett-Packard) T1200 User Manual

Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the
spindle showing the correct orientation.

From the back of the printer, the blue stopper is inserted into the right-side holder.

Ensure both ends of the roll are as close to the spindle stops as possible.

Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll.

Ensure the blue paper stop is pushed in as far as it goes; until both ends are against the
stoppers.

If you are a regular user of different paper types, you can change rolls more quickly if you preload
rolls of different paper types on different spindles. Extra spindles are available for purchase, see

To start this procedure, you must have a roll loaded on the spindle. See 

.

If you have a T1200 series printer, do not try to open both roll covers at once; this may cause

problems. Always close one cover before opening the other.

The first three steps below are optional: you can start with step 4. However, in this case the

printer will not keep track of the length of the roll, and will print no barcode on the roll when it is next
unloaded. So you are recommended to follow all the steps, starting with step 1, unless you have
turned off the Printing paper info option. See 

From the front panel, select the Paper menu icon 

.

34

Chapter 5   Paper handling

ENWW