HP (Hewlett-Packard) LH 6000 User Manual
Chapter 1
General Information
11
Front Panel Console Switch and Indicator Descriptions
Control
Description
DC Power Switch
and LED
and LED
Turns the HP NetServer on and off. This switch is under the door on the front panel.
Push once to turn on, again to turn off. As long as the AC power is connected to the
HP NetServer, standby power is present.
Push once to turn on, again to turn off. As long as the AC power is connected to the
HP NetServer, standby power is present.
l
If the LED is steady green, then the HP NetServer is powered-up.
l
If the LED is flashing green, the HP NetServer is in a power-save mode.
l
If the LED is off, but the two-line display has a message, standby power is
present.
present.
l
To go into power-save mode, depress the power switch; you must press it for
over ten seconds to effect a power down.
over ten seconds to effect a power down.
RESET
RESET
Or
Resets the HP NetServer. This switch may be disabled by Secure mode.
Secure Mode
Switch and
Indicator
Switch and
Indicator
Locks system keyboard, monitor display, and control panel to prevent unauthorized
use. Go to the Setup utility security menu to configure this feature. Secure Mode
indicator illuminates when Secure Mode is enabled.
use. Go to the Setup utility security menu to configure this feature. Secure Mode
indicator illuminates when Secure Mode is enabled.
Status screen
Reports system status.
Red
LED
Yellow
LED
Green
LED
Indicates HP NetServer Status:
Off
Off
Off
Main power is off and the HP NetServer may or may not be on standby
power.
power.
Flashing
Off
Off
Immediate attention required due to a failed component in the HP
NetServer. The HP NetServer may not be fully operational, due to this
condition, such as POST errors.
NetServer. The HP NetServer may not be fully operational, due to this
condition, such as POST errors.
Off
Flashing
Off
Attention required due to a pre-failure condition. This condition may be
caused by a component failure (for example, a redundant fan or power
supply) that could lead to a critical component failure, such as a processor
module exceeding its operating temperature. If the failed component is
redundant, the HP NetServer may still be operating normally.
caused by a component failure (for example, a redundant fan or power
supply) that could lead to a critical component failure, such as a processor
module exceeding its operating temperature. If the failed component is
redundant, the HP NetServer may still be operating normally.
Off
Off
On
The HP NetServer is operating normally.