Sony AR-208S User Manual

Page of 311
3
PRINTING FROM MACINTOSH
22
Basic printing
(part 2)
If the tray runs out of paper during printing
Printing will automatically resume when paper is loaded in the 
tray.
When using the bypass tray, select printer mode with the mode 
select key on the machine, load paper as instructed by the 
message in the display, and then press the [START] key to 
resume printing.
When the 250-sheet paper feed unit is installed:
Note that if the "AUTO TRAY SWITCH" setting in the user 
programs is enabled and there is the same size of paper in 
another tray, the machine will automatically switch to the other 
tray and continue printing.
Cancel a print job
To cancel a print job that is already in progress, select printer 
mode with the mode select key on the machine and then press 
the [CLEAR] key (
) or the [CLEAR ALL] key (
).
"CANCEL PRINT JOB?" will appear in the display. Select "YES" 
and press the [ENTER] key.
When "Paper Feed" is set to "Auto Select"
If "Paper Feed" is set to "Auto Select" in the Print window and the 
correct size of paper for a print job is not loaded in the machine, 
the printing procedure will vary depending on the "FORCED 
OUTPUT" setting in the user programs (see "USER 
PROGRAMS" in the Operation Manual).
When "FORCED OUTPUT" is set to "OFF"
Select printer mode with the mode select key on the machine, 
check the message in the display, load paper in the bypass tray, 
and then press the [START] key to begin printing.
When "FORCED OUTPUT" is set to "ON"
Printing takes place on the paper loaded in the machine, even 
though the paper size is different from the print image size.