Zebra Technologies XiIIIPlus User Manual
Front Panel Controls
Front Panel LCD
23063L-001 Rev. 2 6/21/2004
RXiIIIPlus User Guide
59
ZebraNet
®
Wired Print Server LCD Displays
display only if you have the ZebraNet PrintServer II
installed.
Table 6 • Print Server LCD Displays
LCD
Explanation
IP
RESOLUTION
IP Resolution
Depending on the selection, allows either the user (permanent) or the server (dynamic) to
select the IP address. For more information, see the PrintServer II™ Installation and User
Guide.
• Press the right or left oval to display other choices.
Default: Dynamic
Selections: Dynamic, permanent
Depending on the selection, allows either the user (permanent) or the server (dynamic) to
select the IP address. For more information, see the PrintServer II™ Installation and User
Guide.
• Press the right or left oval to display other choices.
Default: Dynamic
Selections: Dynamic, permanent
IP PROTOCOLS
IP Protocols
If Dynamic was chosen in the previous parameter, this selection determines the method(s)
by which the PrintServer II receives the IP address from the server. For more information,
see the PrintServer II™ Installation and User Guide.
• Press the right or left oval to display other choices.
Default: All
Selections:
If Dynamic was chosen in the previous parameter, this selection determines the method(s)
by which the PrintServer II receives the IP address from the server. For more information,
see the PrintServer II™ Installation and User Guide.
• Press the right or left oval to display other choices.
Default: All
Selections:
All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP
IP ADDRESS
IP Address
This parameter allows you to select the IP address if Permanent was chosen in IP
RESOLUTION. (If Dynamic was chosen, the user cannot select the address.) For more
This parameter allows you to select the IP address if Permanent was chosen in IP
RESOLUTION. (If Dynamic was chosen, the user cannot select the address.) For more
information, see the PrintServer II™ Installation and User Guide.
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.
SUBNET MASK
Subnet Mask
This parameter selects the part of the IP address that is considered to be part of the local
network. It can be reached without going through the default gateway.
• Press the right or left oval to display other choices.
Default: Permanent (user must set)
Selections:
This parameter selects the part of the IP address that is considered to be part of the local
network. It can be reached without going through the default gateway.
• Press the right or left oval to display other choices.
Default: Permanent (user must set)
Selections:
Dynamic (user may set, but server can assign), permanent
DEFAULT
GATEWAY
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed through
if the destination address is not part of the local network.
This parameter allows you to select the IP address that the network traffic is routed through
if the destination address is not part of the local network.
1.
Press the left oval to move to the next digit position.
2.
Press the right oval to increase the value of the digit.