Zebra Technologies 105SL User Manual
Printer Operation
Roll Media Loading
11342L Rev. 8 6/4/2004
105SL User Guide
27
Peel-Only Mode
Refer to
. The following instructions pertain to printers with the peel option only.
To load media in Peel-Only mode (with or without Rewind option), complete
these steps:
these steps:
1.
Press the printhead open lever. The printhead assembly springs up.
2.
Slide out the media supply guide as far from the printer frame as possible.
3.
Place the roll of media on the media supply hanger and orient the media properly.
4.
Slide in the media supply guide so that it just touches, but does not restrict, the edge of the
roll.
roll.
5.
Feed the media under the inner media guide in the print mechanism.
6.
Pull approximately 36 in. (915 mm) of media through the front of the printer.
7.
Ensure that the media is against the inner media guide. Slide in the outer media guide so
that it just touches, but does not restrict, the edge of the media.
that it just touches, but does not restrict, the edge of the media.
8.
Close the printhead assembly.
9.
If your printer has a Peel with a Rewind option, remove the rewind plate and store it
upside-down on the mounting screw on the inside of the front panel.
upside-down on the mounting screw on the inside of the front panel.
10.
Remove the hook from the peel spindle shaft.
11.
Remove several labels from the media liner and then wind the liner once or twice around
the media take-up spindle.
the media take-up spindle.
12.
Reinstall the hook on the peel spindle shaft.
Figure 19 • Peel-Only Mode Loading