Zebra Technologies 105SL User Manual

42

105SL User Guide

6/4/2004 11342L Rev. 8

Overview

After you have installed media and ribbon and printed a configuration label, you can change 
the printer’s settings using the front panel controls. For an overview of the front panel, 
including descriptions of the buttons and lights, see 

. If you need 

to restore the printer to its factory default settings, see 

.

Many printer settings may be controlled by your printer’s driver or label preparation software. 
Refer to the driver or software documentation for more information.

To enter Setup Mode, press SETUP/EXIT. Press either NEXT/SAVE or PREVIOUS to 
scroll to the parameter you wish to set.

Parameters in this section are shown in the order displayed when pressing NEXT/SAVE. 
Throughout this process, press NEXT/SAVE to continue to the next parameter, or press 
PREVIOUS to return to the previous parameter in the cycle.

An asterisk (*) in the upper left-hand corner of the LCD indicates that the value displayed is 
different from the currently stored value.

 Printers that are operating on an IP network can be quickly configured in the following 

ways:
• with the ZebraLink

 WebView (ZebraNet

PrintServer II required). For information, see 

the ZebraNet Networking: PrintServer II Installation and User Guide.

• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For 

information, see the ZebraNet Wireless Print Server User Guide.

You may also press and hold NEXT/SAVE and PREVIOUS to advance quickly 

through the configuration parameters.