Zebra Technologies 105SL User Manual

Configuration and Calibration LCD Displays

11342L Rev. 8 6/4/2004

105SL User Guide

55

HEAD RESISTOR

Depending on the printer model you have, this menu item may not be available. 

For printers with model numbers 10500-2XXX-XXXX and 10500-3XXX-XXXX, the 
head resistor value is set automatically.
Setting the Head Resistor Value: This value has been preset at the factory to match 
the resistance value of the printhead. It does not need to be changed unless the 
printhead is replaced.
Caution • This parameter should be changed only by a qualified service technician.

Before replacing the printhead, look for the label that shows the resistance value 
(ohm value) of the new printhead and note it for the setting (

).

From the front panel, access the HEAD RESISTOR parameter.

Press the (–) key to move to the next digit position; press the (+) key to increase the 
value of the digit.

Caution • Do not set the value higher than that shown on the printhead. Setting a 
higher value may damage the printhead.
Initial Value:

 

Factory-set to match the printhead shipped with your printer.

Default Value: 0500
Range: 0500 to 1175

WEB S.

Press NEXT/SAVE repeatedly to skip these parameters.
Caution • These parameters are automatically set during the calibration procedure. 
They should be changed only by a qualified service technician. Refer to the 
maintenance manual for more information on these parameters.

MEDIA S.
RIBBON S.
MARK S.
MARK MED S.
RIBBON LED
MARK LED