Zebra Technologies 105Se User Manual
Zebra S-Series User’s Guide
51
-ÃlÞlÏÞlÍ"AÏlAYl
2YHUYLHZ
This section contains preventive maintenance information for the Zebra
S-Series Printer. These procedures may be performed by the operator.
S-Series Printer. These procedures may be performed by the operator.
&OHDQLQJ
([WHULRU6XUIDFHV
The exterior surfaces of the printer may be cleaned as required by using a
lint-free cloth. Do not use harsh or abrasive cleaning agents or solvents. If
necessary, a mild detergent solution or desktop cleaner may be used
sparingly.
lint-free cloth. Do not use harsh or abrasive cleaning agents or solvents. If
necessary, a mild detergent solution or desktop cleaner may be used
sparingly.
,QWHULRU
Remove any accumulated dirt/lint from the interior of the printer using a
soft bristle brush and/or vacuum cleaner. This area should be inspected
after every four rolls of media.
soft bristle brush and/or vacuum cleaner. This area should be inspected
after every four rolls of media.
&OHDQLQJ6FKHGXOH
Table 4
AREA
METHOD
INTERVAL
Printhead
Isopropyl alcohol
After every roll of media (or 500
ft. of fanfold media) when
printing direct thermal or after
every roll of ribbon when printing
in thermal transfer mode.
ft. of fanfold media) when
printing direct thermal or after
every roll of ribbon when printing
in thermal transfer mode.
Platen Roller
Isopropyl alcohol
Upper and Lower Media
Sensors
Sensors
Air blow
Media Path
Isopropyl alcohol
Ribbon Sensor
Air blow
Peel/Tear Bar
Isopropyl alcohol
As needed.
Label Available Sensor
Air blow
Monthly.
Cutter Module
Isopropyl alcohol and/or air blow
As needed.