Kodak SRP 30 User Manual

  Tests 

1.  Print an MBL. 

This provides for a calibrated condition of the system. 

2.  Print the PBL right after the MBL: 

• 

With laser point for new paper other than the master paper 
or 

• 

Without laser point if there was an emulsion change only 

1.  Print the MBL on the previous (old) emulsion. 

This provides for a calibrated condition of the system. 

2.  Immediately print a PBL without laser point on the new master paper.  

NOTE:  If the old emulsion was used up before you could print an MBL you can only 

start the calibration of the new paper with a PBL calibration. However, in this 
case be sure that the equipment is calibrated. Otherwise, there may be a 
deviation between the master paper and all other papers. If this is the case, 
perform a complete new calibration. 

If there is too much deviation in the paper styles, a new calibration is recommended. 

1.  Print an MBL on master paper. 

2.  Immediately print a PBL without laser point for all papers other than the master 

paper. 

After manipulations on the laser module or after changing the chemicals, a new 
calibration is recommended: 

1.  Print a PBL with laser point on the master paper. 

2.  Print an MBL. 

3.  Immediately print a PBL with laser point for all papers other than the master 

paper. 

KODAK PROFESSIONAL SRP 30 Laser Printer 

5-9