Zebra Technologies 400 User Manual

Proprietary Statement

This manual contains proprietary information of Zebra Technologies Corporation. It is

intended solely for the information and use of parties operating and maintaining the

equipment described herein. Such proprietary information may not be used, reproduced, or

disclosed to any other parties for any other purpose without the expressed written

permission of Zebra Technologies Corporation.

Product Improvements

Continuous improvement of products is a policy of Zebra Technologies Corporation. All

specifications and signs are subject to change without notice.

FCC Compliance Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that the interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different than that to which the receiver is

connected.

Consult the dealer or an experienced Radio/TV technician for help.

NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded

cables must be used with the unit to insure compliance.
The user is cautioned that any changes or modifications not expressly approved by Zebra

Technologies Corporation could void the users authority to operate the equipment.

Canadian DOC Compliance Statement

This digital apparatus does not exceed the Class A limits for radio noise emissions from

digital apparatus as set out in the radio interference regulations of the Canadian

Department of Communications.

Liability Disclaimer

Zebra Technologies Corporation takes steps to assure that its published Engineering

specifications and Manuals are correct; however, errors do occur. Zebra Technologies

Corporation reserves the right to correct any such errors and disclaims liability resulting

therefrom.

No Liability for Consequential Damage

In no event shall Zebra Technologies corporation or anyone else involved in the creation,

production, or delivery of the accompanying product (including hardware and software) be

liable for any damages whatsoever (including, without limitation, damages for loss of

business profits, business interruption, loss of business information, or other pecuniary

loss) arising out of the use of or the results of use of or inability to use such product, even

if Zebra Technologies Corporation has been advised of the possibility of such damages.

Because some states do not allow the exclusion or limitation of liability for consequential

or incidental damages, the above limitation may not apply to you.

Copyrights

This copyrighted manual and the label printer described herein are owned by Zebra

Technologies Corporation. All rights are reserved. Unauthorized reproduction of this

manual or the software in the label printer may result in imprisonment of up to one year

and fines of up to $10,000 (17 U.S.C.506). Copyright violators may be subject to civil

liability.

All products and brand names are trademarks of their respective companies. All rights