Kodak 20R User Manual
Diagnostics and Troubleshooting
September 2000
5-3
Printer Error Messages
If the error message continues to occur after implementing the possible solutions
from the table below, call your service person.
from the table below, call your service person.
Error
Code
Code
Error Message
Possible Cause
Possible Solution
1
not initialized
Attempting to perform a function
before the printer has initialized.
before the printer has initialized.
Reinitialize the printer.
2
initializing err
Attempting to perform a function
during the initialization process.
during the initialization process.
Wait for initialization to complete and
try the function again.
try the function again.
3
busy
Attempting to perform a function
while the printer is busy performing
another function.
while the printer is busy performing
another function.
Wait for the previous function to
complete and try the function again.
complete and try the function again.
4
out of paper
Paper cassette is empty and the
paper path sensors do not detect
paper.
paper path sensors do not detect
paper.
Load a full paper cassette into the
printer.
printer.
5
end of roll at supply
Printer has run out of paper and the
tail end of the paper has been
rewound to the paper supply area.
tail end of the paper has been
rewound to the paper supply area.
Remove the tail end of the paper at
the supply door and load a full supply
cassette into the printer.
the supply door and load a full supply
cassette into the printer.
6
paper already loaded
“Load Paper” was selected when
paper was already loaded.
paper was already loaded.
Solution not required.
7
supply door open,
please close
please close
The paper supply door was left
open.
open.
Close the paper supply door.
8
front door open, please
close
close
The front door was left open.
Close the front door.
9
back door open, please
close
close
The back door was left open.
Close the back door.
10
takeup door open,
please close
please close
The takeup door was left open.
Close the takeup door.
12
motor busy
A low level motor move command
was issued while the timer motor
was in use.
was issued while the timer motor
was in use.
Wait for the motor move to complete
or stop the motor and reissue the
command.
or stop the motor and reissue the
command.
13
motor setup invalid
A low level motor move command
was issued while the timer motor
was in use.
was issued while the timer motor
was in use.
Wait for the motor move to complete
or stop the motor and reissue the
command.
or stop the motor and reissue the
command.
14
bad printer state
The printer cannot execute the
requested command.
requested command.
Reinitialize the printer.
15
timers busy
A low level motor move command
was issued while the timer motor
was in use.
was issued while the timer motor
was in use.
Wait for the motor move to complete
or stop the motor and reissue the
command.
or stop the motor and reissue the
command.
16
timer spurious interrupt
code
code
A spurious (false) timer interrupt
has occurred.
has occurred.
No solution required.
17
command not
implemented
implemented
The function requested is not
supported in this software release.
supported in this software release.
No solution required.