AMT Datasouth 600 User Manual
Fastmark 600 Series User's Guide
33
Printing the Configuration Label
1. Ensure the printer is powered off.
2. Make sure that Media width of 4 inches is installed and that the MEDIA WIDTH feature
is set for 4.00 inches.
3. Verify that the media is properly loaded and routed as detailed in Loading Media
Section.
4. While pressing and holding the FEED key, power on the printer.
5. When the printer begins to print the configuration label you may release the FEED key.
Note: The feature settings on your printer may vary based on any setup changes made or
firmware version installed in the printer.
When a PAL application is loaded into the printer the Print Sample will indicate this
on the Drive A or Drive B lines
on the Drive A or Drive B lines
Figure 31 – Configuration Print Sample
Media Type
Thermal Transfer
Media Sensing
Gap
Sensor Threshold
70
Media Length
4.00 Inches
Media Width
4.00 Inches
Present Distance
+0.24 Inches
BackFeed Mode
Enable
Present Sensor
Disabled
Cutter Mode
Disabled
Vert Print Align
0.00 Inches
Horz Print Align
+0.20 Inches
Vert Size Adjust
0
Print Darkness
- 6
Print Speed
4
Interface Select
Auto Select
COM1: Baud Rate
9600
COM1: Parity
None
COM1: Data Bits
8
COM1: Handshake
RTS & XON
COM1: PAL Xmit
Disabled
Emulation Mode
PAL Emulation
Date
Not Installed
Time
Not Installed
Daylight Saving
Disabled
Firmware Rev.
110156 A
PAL Boot Drive
Auto Detect
Max Media Length
12.00 Inches
Keypad Lockout
Disabled
Label Count
582
Drive A: (131072)
Empty
Drive B: (262144)
Empty
Drive C: (0)
Empty
Drive D: (32768)
Empty