Yamaha DSP-AX750SE User Manual
70
REMOTE CONTROL FEATURES
• “NG” appears in the display window if programming was
unsuccessful. In this case, start over from step 5.
• This remote control can learn approximately 120 functions.
However depending on the signals learned, “FULL” may
appear in the display before you program 120 functions. In this
case, clear unnecessary programmed functions to make room
for further learning.
appear in the display before you program 120 functions. In this
case, clear unnecessary programmed functions to make room
for further learning.
6
Repeat steps 4 and 5 to program additional
functions.
functions.
7
Press LEARN again to exit from the learning
mode.
mode.
• Learning may not be possible in the following cases:
– When the batteries in the remote control for this unit or other
components are weak.
– When the distance between the two remote controls is too
great or too small.
– When the remote control infrared windows are not facing at
the appropriate angle.
– When the remote control is exposed to direct sunlight.
– When the function to be programmed is continuous or
– When the function to be programmed is continuous or
uncommon.
• “ERROR” appears in the display window if you press more than
one button at the same time.
You can change the name that appears in the display
window on the remote control if you want to use a
different name to the one that is set as the factory preset.
This is useful when you have set the input selector to
control a different component.
window on the remote control if you want to use a
different name to the one that is set as the factory preset.
This is useful when you have set the input selector to
control a different component.
1
Press an input selector button to select the
source component you want to rename.
source component you want to rename.
The selected component name appears in the display
window.
window.
2
Press RE-NAME using a
ballpoint pen or similar
object.
ballpoint pen or similar
object.
3
Press
u
/
d
to select and enter a character.
Pressing d changes the character as follows:
A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash).
(Pressing u changes the characters in reverse order.)
A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash).
(Pressing u changes the characters in reverse order.)
4
Press
j
/
i
to move the cursor to the next
position.
y
If you want to continue setting up names for other
components, press TV MUTE/SELECT and repeat steps 1,
3 and 4.
components, press TV MUTE/SELECT and repeat steps 1,
3 and 4.
5
Press RE-NAME again to exit from the
renaming mode.
renaming mode.
Notes
Notes
LEARN
Changing source names in the
display window
display window
A
B
PHONO
CD
MD/CD-R
TUNER
V-AUX
DVD
VCR 1
DTV/CBL
DVR/VCR2
MULTI CH IN
RE-NAME
TV VOL
PRESET
PRESET
TV MUTE
TV VOL
SELECT
CH
CH
+
+
–
–
TV VOL
PRESET
PRESET
TV MUTE
TV VOL
SELECT
CH
CH
+
+
–
–
RE-NAME
01EN_00_RXV750_GB.book Page 70 Thursday, February 12, 2004 5:15 PM