Bixolon SRP-350 User Manual
Rev. 2.01
- 10 -
SRP-350/352plusA&C
2-2 Operation
2-2-1 Setting the DIP switches
The DIP switches are located on the bottom of the printer. The DIP switches are used to set the printer to perform various
functions. Follow these when changing DIP switches setting :
1. Turn the printer power switch off.
2. Remove the screw on the bottom of the printer and open the
2. Remove the screw on the bottom of the printer and open the
bracket.
3. Flip the DIP switches using tweezers or another marrow-ended
tool. Switches are in when up and off when off down in the
Figure 3-12.
Figure 3-12.
4. The new setting takes effect when you turn on the printer.
Note : Always change DIP switch settings only when the
printer is turned off. Change made with the power on
have no effect and then on again.
have no effect and then on again.
Figure 2-5 Setting the DIP switches
2-2-2 Setting the DIP switch (RS-232C Serial Interface)
• DIP Switch 1
SW
Function
ON
OFF
Default
1-1
Auto Line Feed
Enable
Disable
OFF
1-2 Handshaking
XON/XOFF
DTR/DSR
OFF
1-3 Data
Length
7bits
8bits
OFF
1-4 Parity
Check
Yes
No
OFF
1-5 Parity
Selection
EVEN
ODD
OFF
1-6
OFF
1-7
ON
1-8
Baud Rate Selection (bps)
Refer to the following table 1
OFF
• DIP Switch 2
SW
Function
ON
OFF
Default
2-1 Reserved
-
-
OFF
2-2
Internal bell control
Internal bell disable
Internal bell enable
OFF
2-3 Auto
Cutter
Disable
Enable
OFF
2-4
BUSY Condition
Receive Buffer Full
* Offline
* Receive Buffer Full
* Receive Buffer Full
OFF
2-5
OFF
2-6
OFF
2-7
Print Density
Refer to the following table 2
OFF
2-8
Near-End Sensor Status
Disable
Enable
OFF