Epson 10020 User Manual
If you load MS-DOS from the hard disk, the command prompt
looks like this:
C:\>
The hard disk prompt is different because the Apex
100\20
has
been set up with a special command that changes the
command prompt to show the current directory. (A directory
consists of a group of files stored together under an identifying
name. See Chapter 3 for a complete description of directories.)
The command that changes the command prompt is called
PROMPT and it is stored in a file called AUTOEXEC.BAT.
The AUTOEXEC.BAT file contains a series of commands that
your computer performs each time it loads MS-DOS. You can
add commands to this file to automate a set of procedures you
normally perform each time you turn on the computer. See
Chapter 3 for more information about using the
Chapter 3 for more information about using the
AUTOEXEC.BAT file.
Note
For consistency, this manual uses the same format for the
For consistency, this manual uses the same format for the
command prompt for both drive A and drive C, that is: A>
and C>.
Setting the Time and Date on the Apex 100\20
The first time you use your Apex 100\20, you need to set the
correct date and time for the computer’s real-time clock.
correct date and time for the computer’s real-time clock.
Follow these steps:
1. At the C> prompt,
type DATE
and press Enter. The screen
displays the following:
Current date is Mon 7-24-89
Enter new date (mm-dd-yy):
Setting Up Your System
1-19