DELL 4200 User Manual

Page of 96
Removing and Replacing Parts
4-5
1. Remove the front bezel.
2. From the back of the front bezel, press against the center of the insert 
until the tabs come loose from the bezel.
3. Pull the insert out of the bezel.
To replace a front-panel insert, position the insert over the bay opening from the 
inside of the front bezel and carefully press the insert into place. A tab on each 
side of the insert snaps into a corresponding latch on the inside of the front 
bezel.
D
rives
Figure 4-5 shows an example of drive hardware that can be installed in the com-
puter. Refer to this figure when you perform any of the procedures in the 
following subsections.
Figure 4-5.  Drive Hardware
SCSI hard-disk 
drive bays (6)
SCSI connector 
(BACKPLANE SCSI1)
SCSI2 CD-ROM 
drive
3.5-inch diskette drive
DC power cable
diskette-drive 
interface cable
diskette-drive interface 
connector (FLOPPY)
SCSI interface 
cable
SCSI backplane 
board
system board
SCSI connector
(SCSI2 CD-ROM)