DELL 4200 User Manual
Removing and Replacing Parts
4-23
Figure 4-23. Removing a Terminator Card
Microprocessor SEC Cartridge/Heat Sink Assembly
1. Unplug the temperature sensor cable from the TEMP_n connector on
the system board.
2. Slide the metal clips on the heat sink inward toward each other.
NOTE: Do not remove the clips from the heat sink.
3. Press the microprocessor SEC cartridge release latches toward the car-
tridge, as shown in Figure 4-24, until they snap into position.
WARNING: The microprocessor SEC cartridge/heat sink assembly can
get extremely hot during system operation. Be sure the assembly has
had sufficient time to cool before you touch it.
get extremely hot during system operation. Be sure the assembly has
had sufficient time to cool before you touch it.
WARNING: When handling the microprocessor SEC cartridge/heat
sink assembly, take care to avoid sharp edges on the heat sink.
sink assembly, take care to avoid sharp edges on the heat sink.
terminator card
retaining clip
guide bracket
assembly
assembly
notch
bar
locking mechanisms (2)