DELL 4200 User Manual

4-26

Dell PowerEdge 4200 Systems Service Manual

Guide Bracket Assembly

1. Remove the terminator card or old microprocessor SEC cartridge/heat

sink assembly from the guide bracket assembly (see “Removing the
Terminator Card” or “Removing the Microprocessor SEC Cartridge/
Heat Sink Assembly”).

2. Remove the four screws securing the guide bracket assembly to the sys-

tem board and remove the guide bracket assembly (see Figure 4-26).

System Battery

Figure 4-27. System Battery Removal

1. If possible, enter the System Setup program and record the information

on the system setup screens.

2. Remove the left computer cover.

See “Computer Covers” found earlier in this chapter.

3. Remove the battery.

Pry the battery out of its socket with your fingers or with a blunt, noncon-
ducting object, such as a plastic screwdriver.

To replace the system battery, follow these steps.

1. Orient the new battery with the “+” facing up. Insert the battery into its

socket, and snap it into place.

2. Start the System Setup program, and reset the Time and Date categories.

Also, compare the system configuration information with the copy of the
system configuration settings you made in step 1 of the removal procedure. Restore
any system configuration information that was lost while replacing the battery.

WARNING: The new battery can explode if installed incorrectly. Be
careful to replace the battery as instructed in the following procedure. In
addition, replace the old battery only with one of the same or an equiva-
lent type, as recommended by the manufacturer. Discard the old battery
according to the manufacturer’s instructions.

BATTERY socket

battery