Apple MD094LL/A User Manual
iMac (27-inch, Mid 2010) Symptom Charts — Mechanical
122
2010-09-09
2. Verify if noise sounds like one
or more fans running faster
than expected.
Yes
Fans running fast. Reset SMC
by disconnecting power cord
for ~15 seconds then retest. If
issue continues go to step 3.
No
Go to step 3.
3. Verify if any tape, gasket, cable
label, or cable is touching
the fan blades and causing a
ticking noise
Yes
Secure the material so it
doesn’t touch fan blades. If
tape adhesive has lost its
stickiness, replace that section
of tape
No
Go to step 4.
4. Remove fans and rotate blades.
Check for any dust that could
be clogging the fans. Verify
if fan blades spin smoothly
without interference from fan
housing and fan blades are all
intact.
Yes
Go to step 5.
No
Replace affected fan(s).
X23
5. Run latest available Apple
service utilities then ASD
in stand-alone tests looping
mode, to verify if all sensor or
fans related tests pass.
Yes
Noise issue resolved.
No
Check for correct sensors/fans
connections on logic board.
Check for pinched cables.
Compare with known-good
similar system, and check
for unlisted sensors. Replace
affected sensor/fan.
X22
Stand/Hinge Issues
Symptoms
Quick Check
Stand/Hinge Issues
• Bent stand
• Broken hinge
• Stripped screw/head
• Stripped screw boss
• Unable to install VESA mount (if
• Bent stand
• Broken hinge
• Stripped screw/head
• Stripped screw boss
• Unable to install VESA mount (if
supported on this model)
1. Determine whether damage caused by user /
technician environment, accidental damage, or
abuse. If so, inform user/technician the failures
are not covered by Apple warranties. Refer to
2. For hinge noise issues replace hinge mechanism.
3. For information on selecting the adequate iMac
3. For information on selecting the adequate iMac
VESA Mount Adapter and which computer
models are supported, refer to installation
manuals available at