Emerson 000-VA User Manual

b. Pull the operation and display panel gently, rotate it 90 degrees clockwise and snap it back 

into position, as shown in Figure 8.

c. Pull the logo on the front plastic bezel cover gently, rotate it 90 degrees clockwise and snap it 

back into position. The rotated front plastic bezel cover is shown in Figure 8.

d. Replace the front plastic bezel cover on the Liebert GXT3. At this point, the UPS operation 

and display panel and logo have been rotated 90 degrees clockwise, which provides upright 

viewing for users.

5. Place the Liebert GXT3 and any battery cabinets on the support bases. Each Liebert GXT3 needs 

two support assemblies, as shown in the lower half of Figure 1.

When using the Liebert GXT3 in a rack-mount configuration, the UPS must be supported by a slide 

kit, fixed rails or a shelf.
When using the optional Adjustable Rack Mount Kit, you will use the following instructions. The 

shows the positioning of the rack-mounting brackets. Emerson® recommends taking the internal 

batteries out of the UPS during rack installation. This will make the UPS cabinet lighter and easier 

to handle.

This kit contains parts needed to mount several different models of UPS and external battery 

cabinets into EIA310-D standard four-post racks that are 18-32" deep (457-813mm). The weight limit 

per pair of adjustable rack-mounting brackets is 91 kg (200lb).
Parts included are:

Tools needed for installation are:

• one Phillips screwdriver
• one 7mm wrench

The GXT3 is heavy; see 12.0 - Specifications. The UPS must be installed as near the bottom 

of a rack as possible. If placed too high, it can make the rack top-heavy and prone to tipping 

over.

Rear bracket members

2

Front bracket members

2

Inner bracket members

2

M4 machine screws

16

M4 locking hex nuts

8

M5 machine screws

8