Fluke FLK-TI-SBC3 Leaflet
FLK-TI-SBC3
Charging Base/Power Supply with Adapters
Instruction Sheet
The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a
charging base, power supply, and power outlet adapters.
PN 3481481 August 2009
© 2009 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.
Safety Information
Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke
product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.
A
Warning identifies hazardous conditions and actions that could cause bodily harm or
death.
A
Caution identifies conditions and actions that could damage the Imager or cause
permanent loss of data.
W
Warning
To avoid injury:
Do not disassemble or short circuit the battery pack.
●
Do not expose the battery pack to temperatures above 50 °C (122 °F).
●
Do not incinerate or mutilate the battery pack.
●
Use only ac adapters approved by Fluke for the product to charge the battery or
●
power the product.
Table 1. Symbols
Symbol
Description
P
Conforms to requirements of European Union and European Free Trade Association.
"
Imager connected to battery charger.
;
Conforms to relevant Australian standards.
)
Conforms to relevant Canadian and US standards
W
Important information. See manual.
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
recycling information.
Charging the Battery
Before using the battery pack for the first time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the “Ti32,
TiR32 Thermal Imagers User Manual.”
Specifications
See Table 2 for the specifications.
Table 2. Specifications
Battery Charging
10-15 Vdc 2 A or charge battery pack in Imager with included ac
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
Charging / Power LED
Status
Charging LED
Power LED
off
no battery detected
no dc power input
solid green
charged
dc power present
blinking green
charging
na
blinking red
fault
na
Dimensions
159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature
-10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature
-20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range
10 % to 95 % non-condensing
PO
WER
Ti SBC3
SMA
RT
BA
TTER
Y
CHARGER
3