Gigaset SX353 isdn SX353 User Manual
Product codes
SX353
76
Appendix
C45 isdn / GB-IRL / A31008-M1753-X101-1-7619 / appendix.fm / 18.04.2006
Appendix
Care
Wipe the base and handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare. You will find the most frequently asked
questions and answers below.
!
What has happened
when …
Possible cause
Possible solution
… the display is blank?
The handset is not switched on.
The batteries are flat.
Press the end call key
a
for about 2 seconds.
Charge or replace the batteries.
… the handset fails to respond
to a key press?
The keypad lock is activated.
Press the hash key
#
for about 2 seconds to deacti-
vate the lock.
… Base or Searching for
Base
, for example, is flashing
on the screen?
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Move the handset nearer to the
base.
Register the handset (page 9).
Check the power connector at
the base.
… the handset does not ring? The ringer is switched off.
Switch on the ringer in the
handset or the base S150.
… the incoming call number is
not displayed even though
CLIP is set?
Calling Line Identification is
blocked.
The caller must ask his network
provider to enable the identifi-
cation of his number (CLI).