DELL 2T227 User Manual
D e l l Po w e r C o n n e c t R P S - 6 0 0 S e t u p G u i d e
11
Mounting Instructions
NOTICE: Before you install the PowerConnect™ RPS-600, consult your
PowerConnect switch User's Guide to confirm that your switch supports the
PowerConnect RPS-600 Redundant Power Bank.
PowerConnect RPS-600 Redundant Power Bank.
Installing the PowerConnect RPS-600 on a Flat Surface
You can install the RPS-600 on any appropriate level surface that can safely
support the weight of the switches, the RPS-600, and their attached cables.
There must be adequate space around the RPS-600 for ventilation and to
access cable connectors.
support the weight of the switches, the RPS-600, and their attached cables.
There must be adequate space around the RPS-600 for ventilation and to
access cable connectors.
To install the RPS-600 on a flat surface:
1
Set the RPS-600 on the flat surface and check for proper ventilation.
NOTICE: Allow at least 2 inches (5.1 cm) on each side for proper ventilation
and 5 inches (12.7 cm) at the back for power-cord clearance.
2
Attach rubber feet on each marked location on the bottom of
the chassis.
the chassis.
The rubber feet are optional, but recommended to keep the unit
from slipping.
from slipping.
Installing the PowerConnect RPS-600 in a Rack
The RPS-600 can be installed in most standard 19-inch racks.
NOTE: For racks that are not prethreaded, cage nuts are provided.
To install the RPS-600 in a rack:
1
Use the supplied screws to attach a mounting bracket to each side of
the RPS-600.
the RPS-600.
2
Position the RPS-600 in the rack and align the holes in the mounting
bracket with the holes in the rack.
bracket with the holes in the rack.
3
Insert and tighten two screws appropriate for your rack through each of
the mounting brackets.
the mounting brackets.