ADC 1000 User Manual
ADCP-92-063 • Issue 1 • May 2005
Page 7
© 2005, ADC Telecommunications, Inc.
3.2
10/100 Mb/s Module
OptEnet Chassis should already be installed, power supplies installed, and power connections made
before installing OptEnet Media Converter with SFP Modules. Media converter module can be
safely removed and installed into a powered chassis. Module installation is shown in
before installing OptEnet Media Converter with SFP Modules. Media converter module can be
safely removed and installed into a powered chassis. Module installation is shown in
.
Figure 3. Installing Media Converter Module
1. Locate the designated slot in the chassis for the module.
2. Slide OptEnet media converter into slot and plug it into the connector on the backplane.
Modules can be plugged into any empty slot in the chassis. All fiber connectors are mounted
in straight retainers. The module is held in place with thumbscrew fasteners.
in straight retainers. The module is held in place with thumbscrew fasteners.
3. Secure the module in place by tightening the captive thumbscrews on each end. Be sure
that they are properly threaded before tightening.
4. If not already installed insert SFP into OptEnet media converter until you hear it click in place.
Danger: To avoid the possibility of severe and potentially fatal electric shock, never install
electrical equipment in a wet location or during a lightning storm.
electrical equipment in a wet location or during a lightning storm.
Caution: Electronic modules can be damaged by electrostatic discharge (ESD). To prevent this,
take the following precautions:
take the following precautions:
• Wear an anti-static-discharge wrist strap while handling modules.
• Place modules in anti-static packing material when transporting or storing them.
• Place modules on an approved, electrically grounded, anti-static mat when working on them.
20473-A
MEDIA
CONVERTER
MODULE