AEG 10000 User Manual

41 

The UPS offers various interfaces to manage the system and 
to comfortable readout state information and important 
parameters. The communication protocol is optimized for 
operation with the shutdown and UPS management software 
“CompuWatch” from AEG. To connect the UPS to your 
computer use the provided RS232 communication cable by 
attaching them to a free port of your pc. 
RS232 interface: The interface is connected via a 9 pole  
Sub-D connector on the back of the unit (pos. 4 p. 26). PINs: 
2 = RxD; 3 = TxD; 5 = GND. 

If the cover on the rear of the UPS is removed (pos. 8 p. 26), 
additional optionally available communication components 
can be installed there. 
AS/400 board:

 Slot card with status messages, realised via 

potential-free relay contacts 
USB board:

  Slot card for external USB connection 

  Slot card for direct connection of the UPS to 

the Ethernet network with RJ 45 (TCP/IP) 
Details can be found in the description enclosed with the 
particular optional component. Other boards are in 
preparation.  

i

 

The usage of the communication slot deactivates 
the RS232 interface from chapter 7.1. 

The "CompuWatch" software specially developed for these 
purposes by AEG continuously checks the mains supply and 
the UPS status.