Panasonic MDDDT5540 User Manual

- 53 -

Preparations

and

Adjustments

Driving method

Ball screw + direct coupling

Ball screw + timing belt

Timing belt

Gear, or rack & pinion

Others: lower stiffness

Mechanical stiffness

4 Å ` 8

3 Å ` 6

2 Å ` 5

1 Å ` 3

1) Start PANATERM“, and click on "Auto tuning"

in the window menu to open the automatic

tuning screen.

2) Move the bar for mechanical stiffness to set the

stiffness.To start from smaller value (1).

3) Click on [Start] button to execute automatic tun-

ing.

• CN I/F pin 2: Servo-ON

• Pr ID (Notch Frequency) = 1500

4) 15 seconds, the motor repeats the cycle 5 times(at

most), which consists of two CCW revolutions and

two CW revolutions. Note that this process doesn't

necessarily repeat 5 cycles and this is not abnormal.

Value is entered in the post-application column after

tuning.

5) Download the obtained gain values to EEPROM. Note that if you turn off the power before down-

loading, the gain values will be lost.

How to Use "Normal Auto-Gain" Tuning

Automatic tuning is available when the gain adjustment rotary switch GAIN is set to "0" position only.

<Notes>

• Never perform normal automatic tuning with single motor nor with single amplifier. Otherwise, Pr20

(inertia ratio) becomes zero, possibly resulting in oscillation.

C a u s e

Either one of Alarm, Servo-Off or

Position Error Counter Clear ac-

t i v a t e d .

The load inertia cannot be cal-

c u l a t e d .

CL/INTSPD 2 (4 pin) of CN I/F

i n p u t

S y m p t o m

E r r o r m e s s a g e

displayed

Values of gain affecting

parameters (e.g. Pr10)

doesn't change.

Motor does not turn.

Remedy

• Avoid operation near the limit switch or home

position sensor.

• Turn to Servo-ON.

• Cancel the Position Error Counter Clear.

• E x e c u t e a g a i n w i t h P r 1 0 a n d P r 11

r e d u c e d t o 1 0 a n d 5 0 r e s p e c t i v e l y.

• Execute the manual adjustment.

(Calculate and input load inertia.)

Make CL/INTSPD 2 (4 pin) of CN I/F OFF.