Panasonic A4P Series User Manual

102

Starting from initial LED status,Press        six time after pressing       , then press

to make a display to

Copying completes normally.

Error display

<Remarks>
If error is displayed, 
repeat the procedures
from the beginning.

Press       .

When you keep on pressing       , 
a dot (  ) moves to the left.

 

The positioning parameter is 
copied from the console into the 
servo driver.

The servo parameter is copied 
from the console into the servo 
driver and the driver type code of 
the servo parameter is written into 
EEPROM (console).

<Remarks>
Don't disconnect the console from the driver between                      to                     .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.

<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector, 
misoperation due to noise or failure of console.

Press        to call for 

    EXECUTION DISPLAY of

Keep pressing         until 

the console display (LED) 

change.

“      ” increases by 
pressing        (approx. 3sec) 
as the left fig. shows.

To move to the next process, press        .

When you have finished the copy, press        to return to                                  .

Check whether or not to 
transfer the read parameter 
to the servo driver.

If a type code stored in EEPROM (console) 
and another type code of servo driver are 
different from each other.