Panasonic A4P Series User Manual

96

• When you change the parameters which contents become valid after resetting,                   will be 
  displayed after finishing wiring.  Turn off the control power once to reset.

Note 1) When writing error occurs, make writing again. If the writing error repeats many times, 

this might be a failure.

Note 2) Don't turn off the power during EEPROM writing.  Incorrect data might be written. 

If this happens, set up all of parameters again, and re-write after checking the data.

Note 3) Between                   and                   , take care not to pull out a console connector from a servo

driver main unit. If the connector is pulled out accidentally, insert the connector again and retry
from the beginning.

<Notice>
When you have set the parameters, write the parameters into EEPROM. If you turn the power supply 
off before writing the parameters into EEPROM, those parameters are cleared.

Starts writing.

Finishes writing

Writing completes

Writing error

Starting from the initial LED status, 
press        three time after pressing       ,
then brings the display of 
EEPROM Writing Mode, 

Keep pressing
until the display changes to                        when you execute writing.

“      ” increases while 
keep pressing        
(for approx. 5sec) as 
the right fig. shows.

Press        to make 
EXECUTION DISPLAY to

To move to the next process, press       .