Telex MS-2002 User Manual
13
All Talk
You can talk to all intercom stations that currently have their listen keys activated. This applies to both channels of the
MS-2002, as well as all talk channels of any connected EMS-4001 Expansion Stations.
MS-2002, as well as all talk channels of any connected EMS-4001 Expansion Stations.
To use All Talk, do the following:
1.
If you are using manual microphone activation instead of VOX, verify the proper microphone switch is turned on
(either Headset or Panel Mic).
(either Headset or Panel Mic).
2.
Press and hold the All Talk key while talking.
3.
Release the key when finished.
NOTE:
To insure the All Talk key is never accidentally left in the on position, it does not latch.
Public Address
If the PA (Public Address) output on the back panel of the MS-2002 is connected to a public address system, you can talk on
the public address system.
the public address system.
To use the public address system, do the following:
1.
If you are using manual microphone activation instead of VOX, verify the proper microphone switch is turned on
(either Headset or Panel Mic).
(either Headset or Panel Mic).
2.
Press and hold the PA key while talking.
3.
Release the key when finished.
NOTE:
To insure the PA key is never accidently left in the on position, it does not have latching operation.
Turning the Program Inputs On and Off
To turn the program inputs on and off, do the following:
1.
Verify program inputs have been connected at the back panel and that the program sources are on.
2.
Press and hold the Mic Kill key for about two (2) seconds, then release it.
It should now be lit green to indicate that the MS-2002 is in programming mode.
It should now be lit green to indicate that the MS-2002 is in programming mode.
NOTE:The current status of the program inputs is indicated by the Talk keys. If the channel 1 Talk key is lit, the
program 1 input is currently activated to channel 1; if the channel 2 talk key is lit, program 2 is activated to
channel 2. Tap either Talk key to turn the program input on or off.
channel 2. Tap either Talk key to turn the program input on or off.
3.
When the program inputs are configured as desired, tap the Mic Kill key to exit programming mode and return to
normal operation.
normal operation.
4.
Adjust program 1 and 2 levels via the trimmers on the back panel of the MS-2002.
Using Mic Kill
If the Mic Kill feature has been enabled, you can use it to deactivate all talk keys on a single channel or on all channels. This
feature is useful when a remote talk key has been left on and is causing unwanted noise on a channel.
feature is useful when a remote talk key has been left on and is causing unwanted noise on a channel.