Powerware 10001100 kVA User Manual
UPS SYSTEM INSTALLATION
EATON Powerware
®
9395 UPS (1000–1100 kVA) Installation and Operation Manual
S
164201764 Rev 1 www.powerware.com
4−33
4.9.3
X−Slot Connections
NOTE LAN and telephone drops for use with X−Slot cards must be provided by the customer.
NOTE When installing external wiring to X−Slot cards, conduit must be installed to the UPS cabinet. When
installing internal wiring to X−Slot terminals, route the wiring through the internal opening in the X−Slot
communication bay.
NOTE When installing external wiring to X−Slot cards, conduit must be installed to the UPS cabinet. When
installing internal wiring to X−Slot terminals, route the wiring through the internal opening in the X−Slot
communication bay.
For installation and setup of an X−Slot card, contact an Eaton service representative
(see page 1−8).
(see page 1−8).
To install wiring to connections:
1.
If not already installed, install the LAN and telephone drops.
2.
3.
Remove the right interface entry conduit landing plate to drill or punch holes (see
Figure 4-16 on page 4−18).
Figure 4-16 on page 4−18).
4.
Reinstall the interface entry plate and install the conduit.
5.
Route and install the LAN, telephone, and other cables to the appropriate X−Slot
cards. See Figure 4-22 on page 4−27 and Figure 4-28 for X−Slot communication
bay locations.
cards. See Figure 4-22 on page 4−27 and Figure 4-28 for X−Slot communication
bay locations.
6.
Close the door and secure the latch.
7.
Refer to the manual supplied with the X−Slot card for operator instructions.
X−Slot Communication Bay 1
X−Slot Communication Bay 2
X−Slot Communication Bay 3
X−Slot Communication Bay 4
Figure 4-28. X−Slot Communication Bays