Powerware 9315 UPS User Manual

Communication

7−6

EATON Powerware

®

 9315 UPS (200–300 kVA) Operation Manual  

S  164201036 Rev G  www.powerware.com

7.5 Configuring the Serial Ports

You must configure the port for communication using the LCD screen and buttons on the
UPS Monitor Panel.

Select Port 1 from the Setup menu to display one of the Setup Port screens. The screens
for Port 1 and Port 2 are identical, and allow you to specify settings for the two serial
communication ports. Figure 7-5 shows the Setup Serial Port 1 screen.

NOTE  You should configure only Port 1 unless field service has performed a wiring
change for Port 2.

Statistics Graphics

Setup

Events

Meters

Setup Serial Port 1

Rate

9600

Data/Stop

8     1

Handshaking

XON / XOFF

Save

NO

Time

Mode

Port 2

Battery

100%

Percent

Figure 7-5. Setup Serial Port 1 Screen

A small return arrow (

) appears in the upper right corner of the Setup Port screen. This

arrow is a reminder that you can press the 

 button on the Monitor Panel to toggle the

buttons between the menu box and the information area.

If the scroll bar is in the menu box, press the 

 button to toggle to the information

area. The first setting (Mode) is highlighted. Press the   or   button to move the highlight
to the setting you want to change. To scroll through the available options for that setting,
press the   or   button.

To save the settings upon exit from this screen, be sure the Save field is set to YES.