Powerware Model V-2000B User Manual

Hardware Interface = 25 

A LTC time code input is provided on the LTC IN BNC connector.  This input may be selected 
by means of the On-Screen user interface and recorded as a time code reference.  The LTC 

input provides a >10k ohm termination. 

An LTC time code output is provided on the LTC OUT BNC connector.  It may be selected by 
means of the On-Screen user interface to output time code from any of the three video 

channels during playback.  The LTC output has a low source impedance of <5 ohms. 

Attach the alphanumeric keyboard to the purple 5-pin KEYBD connector to control the server 

and manage clips with the On-Screen graphic user interface.  Note that the server will only 

recognize the keyboard if it is attached before power up.  

A two-button scroll mouse is provided with the Image Server.  Plug the mouse into the green 

5-pin MOUSE port.  Note that the server will only recognize the mouse if it is attached before 

power up. 

A VESA-compliant computer monitor may be connected to the 15-pin VGA video port.  The 
Image Server resolution is fixed at 1024 x 768 pixels, with a refresh rate of 72 Hz.  This is 

best-viewed on 17-inch or larger monitors.  360 Systems does not provide monitors for the 

server.  Note: Do not use older monitors that do not state they are VESA compliant. 
 

The system board serial port is not used.  Make no connection. 
 

The system board USB ports are not used.  Make no connection. 

An IEC mains socket is provided on the rear panel for power input.  The Image Server  will 

accept worldwide power sources in the range of 100-240 volts AC, 50-60 Hz.  The server is 

shipped with a power cord appropriate for the region in which it is sold.  Replace the power 

cord only with one of the same type and rating.