Cannon 3035 User Manual

NetWare Print Service Settings

U

s

ing a NetW

a

re 

N

e

tw

o

rk 

(Wi

ndo

w

s

)

To print using a NetWare network, you need to specify print service settings, 
including print server and queue settings. You can use the software listed below to 
specify the print service settings from your computer.

•

NWADMIN or PCONSOLE (Novell software provided with NetWare)

•

Canon utilities (NetSpot Device Installer, etc.)

IMPORTANT

 

•

To specify the print service settings from NWADMIN or NetSpot Device Installer, the 
computer must have Novell Client (NetWare Client by Novell) installed. 

•

The following procedures describe a sample NetWare setup. Depending on your 
environment, the actual setup procedure may differ.

NOTE

 

•

You can specify the print server settings on the NetWare server and the print service 
settings of the machine at the same time, using NetSpot Device Installer. For instructions 
on how to specify the settings, see online help of NetSpot Device Installer.

•

For more information on NetSpot Device Installer, see the Reference Guide.

 

Before specifying print service settings, refer to the following descriptions to 
determine the type of print service you are using.

NOTE

 

•

Normally with NetWare 4.x or later, it is recommended that you use NDS print service. 
With NetWare 3.2, it is recommended that you use Bindery print service. This manual 
describes procedures for these two combinations only.

•

With NetWare 5.x, you can use NDPS (Novell Distributed Print Services).
For NDPS settings, see the NetWare manual.

•

With NetWare 6, you can use iPrint print service. For iPrint settings, see the NetWare 
manual.

■ NDS (Novell Directory Service) and Bindery Mode

The machine network supports both the NDS and Bindery mode.
Determine the appropriate mode according to the network environment you are using. (If 
you are using NetWare 3.2, only the Bindery mode is available.)