Marantz Model VP-10S1 User Manual

Loosen the 2 screws that lock down the lamp cover.
(Slotted head screwdriver required.)

Detach the lamp cover in the direction of the arrow.

Remove the 2 screws that lock down the lamp shield.
(Phillips screwdriver required.) Pull the lamp shield
downward as indicated in the below figure and detach.

Loosen the 2 screws that lock down the lamp unit.
(Slotted head screwdriver required.) Grab the lamp unit
by the handle and pull the unit out toward you.

Install a new lamp unit securely in the correct orientation.
Lock the lamp unit in place with the 2 screws. (Slotted
head screwdriver required.) Fold the handle over as it
was before.

Fit the top end of the lamp shield back into place as
shown below, followed by the bottom end. Lock the lamp
shield in place with the 2 screws removed in step 7.
(Phillips screwdriver required.)

Fit the bottom end of the lamp cover back into place as
shown below, followed by the top end. 

Lock the lamp cover in place with the 2 screws loosed in
step 5. (Slotted head screwdriver required.)

Plug in the AC power cable, turn on the projector and
project an image.

• If you replaced the lamp before 1,500 hours of service,

see “Reset Lamp Life” (

☞

pg. 32).

• If you replaced the lamp after 1,500 hours of service,

see “Resetting the Lamp Life Counter” (

☞

pg. 36).

1

2

2

2

2

2

1

1

2

2

1

1

2

1

1

1

1

2

Lamp cover

Lamp unit

Lamp shield

Lamp shield

New lamp unit