Marantz VP-11S1 User Manual

z

☞

Connect the supplied AC power code.

x

Connect the analog RGB output from an IBM VGA
or compatible equipment.

c

Terminals 1 and 2 have each Y, P

B

/C

B

, P

R

/C

R

terminals. Connect them to the component video
output of a video device, AV amp/processor, DVD
player, etc.

v

Connect the S-VIDEO output from a video
equipment.

b

Connect the composite video output from a video
equipment.

n

When the unit is turned on, 12V is output. When the
unit is turned off, no voltage is output. This allows
such as a powered up/down screen,whenever the
projector is turned on or off.

• Do not use TRIG.1 and TRIG.2, as the power

source.

• To connect with external devices, use an

ordinal 3.5mm mini-plug (mono) cable.

m

By connecting this projector to another Marantz
audio component using a supplied System Control
cable, you can remotely operate the components
as a single system.

• When connecting to component with a remote

sensor (such as the SR9500,SR8500), be sure
to connect the "REMOTE CONTROL IN" jack
of this projector to the "REMOTE CONTROL
OUT" jack of the component with the remote
sensor.

Note:
For connections, always use the included bus
control adaptor cable.

,

Select ON or OFF at each aspect mode, such as
Full, Normal, Zoom, V-Stretch and Through to
control screen aspect ratio with powered up/down
dual aspect ratio screen.

• Do not use TRIG.1 and TRIG.2, as the power

source.

• To connect with external devices, use an

ordinal 3.5mm mini-plug (mono) cable.

.

Connect the digital signal (TMDS compliant, single
link only)

Note:
To use the HDMI terminal, please follow the
cautions on page 10.

⁄0

Select ON : The terminal panel lights up.

⁄1

This is the control port for the custom installer.

z

☞

Lift the projector and turn the adjustment lever right
or left. The adjustable feet will extend from the
projector. Then, release the lever, the adjustable
feet is locked.

x

z

z

x

x

VP11S1U_01_ENG  06.4.6  1:09 PM  ページ5