Planar PD7010 User Manual
Resetting the Lamp
After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following:
1.
Press the Menu button to open the OSD
menu.
2.
Press the cursor ◄ ► button to move to
the Service menu.
.
Press the cursor ▲▼ button to move
down to Lamp Hour Reset.
.
Press the cursor ◄ ► or Enter button.
A message screen appears.
.
Press the cursor buttons in this order:
▼ ▲ ◄ ►.
The Status menu appears again showing
the Lamp Hours reset to zero.
Cleaning the Projector
Cleaning the projector to remove dust and grime will help ensure trouble-free operation.
Be sure to turn off and unplug the projector at least an hour before clean-
ing. Failure to do so could result in a severe burn.
Use only a dampened cloth when cleaning. Do not allow water to enter the
Use only a dampened cloth when cleaning. Do not allow water to enter the
ventilation openings on the projector.
If a little water gets into the projector interior while cleaning, leave un-
If a little water gets into the projector interior while cleaning, leave un-
plugged in a well-ventilated room for several hours before using.
If a lot of water gets into the projector interior when cleaning, have the pro-
If a lot of water gets into the projector interior when cleaning, have the pro-
jector serviced.
1.
2.
3.
4.
Cleaning the Lens
You can purchase optic lens cleaner from most camera stores. Refer to the following to clean the
projector lens.
Apply a little optic lens cleaner to a clean soft cloth.
(Do not apply the cleaner directly to the lens.)
Lightly wipe the lens in a circular motion.
Lightly wipe the lens in a circular motion.
CAUTION
Do not use abrasive cleaners or solvents.
To prevent discoloration or fading, avoid getting cleaner on the projector
To prevent discoloration or fading, avoid getting cleaner on the projector
case.
1.
2.
2.
1.
2.