Panasonic PT-LC75E User Manual

Insert the lithium battery which is
supplied with the remote control
unit, making sure that the polarities
are correct.

# While pushing the battery

$ Insert the battery into the

% Insert the battery holder.

NOTE:
B Do not drop the remote control

unit.

B Keep the remote control unit

away from liquids.

B Remove the battery if not using

the remote control unit for long
periods.

B Use only CR2025 batteries as

replacement batteries.

If the remote control unit is held so
that it is facing directly in front of the
front or rear remote control signal
receptors, the operating range is
within approximately 7 m (23´) from
the surfaces of the receptors.
Furthermore, the remote control unit
can be operated from an angle of
±30 ° to the left or right and ±15 °
above or below the receptors.

NOTE:
B If there are any obstacles in

between the remote control unit
and the receptors, the remote
control unit may not operate
correctly.

B If strong light is allowed to shine

onto the remote control signal
receptor, correct remote control
operation may not be possible.
Place the projector as far away
from light sources as possible.

B If facing the remote control unit

toward the screen to operate the
projector, the operating range of
the remote control unit will be
limited by the amount of light
reflection loss caused by the
characteristics of the screen
used.

B Read the instruction manual for each system component carefully before

connecting it.

B Turn off the power supply for all components before making any

connections.

B If the cables necessary for connecting a component to the system are not

included with the component or available as an option, you may need to
fashion a cable to suit the component concerned.

B If there is a lot of jitter in the video signal which is input from the video

source, the picture on the screen may flicker. In such cases, it will be
necessary to connect a TBC (time base corrector).

B It may not be possible to connect some types of computer. Refer to the list

of compatible signals on page 52.

B The pin layout and signal names for the S-VIDEO IN connector are shown

below.

#

Earth (Luminance signal)

Earth (Colour signal)

Luminance signal

Colour signal

$
%
&

B The pin layout and signal names for the RGB/YP

B

P

R

(RGB1 IN/RGB2 IN)

connector are shown below.

#

R/P

R

G/G·SYNC/Y

B/P

B

SDA

$
%
.
/

HD/SYNC

0

VD

1

SCL

Pin + is spare.
Pins &–*, , and - are for earth.
Pins . and 1 functions are only valid when
supported by the computer

#

$

%

&

External view

-

1

#

'

,

(

External view

Match the “+”
surface of the
battery with the
“+” marked side of
the battery holder.