Panasonic PT-LB50SE User Manual

(480i, 576i, 480p, 576p, 1 080/60i,
1 080/50i, 720/60p and VGA480
signals only)

This sets the signal that is input to
the PC 1 IN and PC 2 IN/PC 1 OUT
connector.
Normally “AUTO” should be
selected. RGB or YP

B

P

R

is selected

automatically depending on the
synchronising signal status.
If an image is not projected
correctly, select “RGB” or “YP

B

P

R

”

in accordance with the input signal.

You can adjust the volume of the
sound that is output from the
projector’s built-in speaker and
VARIABLE AUDIO OUT connector. 

This setting should be changed in
accordance with the projector
setting-up method. (Refer to page
18.)

FRONT/DESK
When the projector is placed on a
desk or similar in front of a screen.

FRONT/CEILING
When the projector is placed in front
of a screen and suspended from a
ceiling using a ceiling bracket (sold
separately).

REAR/DESK
When using a translucent screen
and the projector is placed on a
desk or similar.

REAR/CEILING
When using a translucent screen
and the projector is suspended from
a ceiling using a ceiling bracket
(sold separately).

Set “HIGHLAND” to “ON”, when
using this projector at high
elevations (above 1 400 m) only.