Panasonic PT-EX800Z User Manual
Chapter 5 Maintenance — Maintenance/replacement
ENGLISH - 133
Replacing the unit
Lamp unit
The lamp unit is a consumable component. Refer to “When to replace the lamp unit” (x page 133) for details about the replacement cycle.
When purchasing the optional Replacement Lamp Unit (Model No.: ET-LAE300), consult your dealer.
It is recommended that you request a qualified technician to replace the lamp unit. Consult your dealer.
When purchasing the optional Replacement Lamp Unit (Model No.: ET-LAE300), consult your dealer.
It is recommended that you request a qualified technician to replace the lamp unit. Consult your dealer.
Warning
Replace the lamp unit after the lamp has cooled (after waiting at least one hour).
The high temperature inside the cover will cause burns.
Notes on the replacement of the lamp unit
f
A Phillips screwdriver is necessary when replacing the lamp unit.
f
Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object. Handle with care.
f
Do not disassemble or modify the lamp unit.
f
When replacing the lamp unit, be sure to hold it by the handle because its surface is pointed and its shape is protruded.
f
The lamp may rapture. Replace the lamp unit carefully so the glass fragments of the lamp do not scatter. While attaching the projector to the
ceiling, do not work right under the lamp unit or do not conduct work while your face is near the lamp unit.
f
The lamp contains mercury. When disposing of used lamp units, contact your local authorities or dealer for correct methods of disposal.
Attention
f
Panasonic takes no responsibility for any damage or malfunction of the product resulting from use of lamp units which are not manufactured
by Panasonic. Use only specified lamp units.
Note
f
The model numbers of accessories and optional accessories are subject to change without prior notice.
When to replace the lamp unit
The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary to replace the lamp unit
regularly. The estimated duration before replacement is 3 000 hours, but the lamp may go off before reaching to 3 000 hours, depending on
the characteristics of the individual lamp, usage conditions, and the installation environment. It is recommended that the Replacement Lamp
Unit be prepared earlier.
If you continue to use the lamp unit after 3 000 hours has elapsed, the lamp turns off automatically after approximately 10 minutes, as it may
If you continue to use the lamp unit after 3 000 hours has elapsed, the lamp turns off automatically after approximately 10 minutes, as it may
cause malfunction of the projector.
On-screen display
REPLACE LAMP
Lamp indicator
Over 2 800 hours
The message is displayed for 30 seconds. Pressing
any button on the control panel or remote control
within 30 seconds will clear the message.
The indicator lights in red even during the standby
mode.
Over 3 000 hours
The message remains displayed until you press any
button.
Note
f
To predict when to replace the lamp, check the lamp runtime displayed at [LAMP : TOTAL] in [STATUS] (x page 96).
f
3 000 hours is only the target for replacement and not the warranty time.
How to replace the lamp unit
Attention
f
While attaching the projector to the ceiling, do not work right under the lamp unit or do not conduct work while your face is near the lamp
unit.
f
Do not remove or loosen the screws other than specified ones when replacing the lamp unit.
f
Make sure to attach the lamp unit and the lamp cover securely.