Panasonic PT-EZ770Z User Manual
Chapter 4 Settings — [PROJECTOR SETUP] menu
90 - ENGLISH
Setting [NO SIGNAL SHUT-OFF]
A function that automatically switches the power of the projector to standby if there is no input signal for a certain period of time. The time
before switching to standby can be set.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[DISABLE]
Disables the No signal shut-off function.
[10MIN.] - [90MIN.]
Allows you to set in ten minutes intervals.
Setting [STANDBY MODE]
Set the power consumption during the standby.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
2) Press the <ENTER> button.
f
The
[ECO MANAGEMENT] screen is displayed.
3) Press as to select [STANDBY MODE].
4) Press qw to switch the item.
4) Press qw to switch the item.
f
The items will switch each time you press the button.
[ECO]
Use this setting to reduce power consumption during standby.
[NORMAL]
Use this setting to use the network function during standby.
Note
f
When [ECO] is set, the network function and some RS-232C commands become inoperable during standby. When [NORMAL] is set, the
network function becomes operable during standby.
f
When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with
when [NORMAL] is set.
f
The [STANDBY MODE] settings are not reset to their factory defaults when [ALL USER DATA] in [PROJECTOR SETUP] menu →
[INITIALIZE] (x page 98) is executed.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1) Press as to select [SCHEDULE].
2) Press qw to switch the item.
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (x page 90) or “How to set a
program” (x page 91) for how to set the schedule.
Note
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1) Press as to select [SCHEDULE].