Panasonic PT-F200NTE/PT-FW100NTE User Manual

37

This page indicates the projector status.
To access this page from other pages, click [Status] at the left of the window.

The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] 

ĺ

[Reload Page].

On this window, click the [Status information] tab.

On this window, click the [Network status] tab.

If [SELF TEST Error(Detail)] appears on the 
monitored information window, click it to view the error 
details.

MAIN CPU BUS

There is a problem with a microcontroller circuit. Contact your dealer.

FAN

There is a problem with the fan or fan drive circuit. Contact your dealer.

INPUT/OUTPUT AIR TEMP.

Excessive temperature by the air intake or around the lamp area. 
The following may be causing the problem. 
• The ambient temperature is too hot; the projector may be near a heater
• The exhaust vent is obstructed

LAMP REMAIN TIME

The lamp has been used for longer than its rated useful life, and it is time to replace it.

LAMP STATUS

The lamp could not be lit. 
Allow the bulb of the light source to cool, and then turn on the projector.

ARF UNIT

ARF UNIT is not installed or remaining filter level is low. 
See instruction manual of the projector for detail.

INPUT AIR TEMP.SENSOR

There is a problem with the air intake temperature sensor. Contact your dealer.

OUTPUT AIR TEMP.SENSOR

There is a problem with the exhaust temperature sensor. Contact your dealer.

BATTERY

The battery must be replaced. Contact your dealer.