Panasonic PT-LB80NTU User Manual

Do not short-circuit, heat or disassemble the 
batteries or place them into water or fire.
 

Failure to observe this may cause the batteries to 
overheat, leak, explode or catch fire, and burns or 
other injury may result.

When inserting the batteries, make sure the 
polarities (+ and -) are correct.
 

If the batteries are inserted incorrectly, they may 
explode or leak, and fire, injury or contamination of 
the battery compartment and surrounding area may 
result.

Use only the specified batteries.
 

If incorrect or different kind of batteries are used, they 
may explode or leak, and fire, injury or contamination 
of the battery compartment and surrounding area 
may result.

Do not mix old and new batteries.
 

If the batteries are inserted incorrectly, they may 
explode or leak, and fire, injury or contamination of 
the battery compartment and surrounding area may 
result.

Remove the used batteries from the remote control 
promptly.
 

If you leave used batteries in the remote control for 
an extended period of time, it may cause liquid 
leaking, abnormal internal temperature rising or 
explosion.

If not using the projector for an extended period of 
time, disconnect the power plug from the wall outlet 
and remove the batteries from the remote control.
 

If dust builds up on the power plug, the resulting 
humidity may damage the insulation, which could 
result in fire.

 

Keeping or leaving the remote control with batteries 
inside may cause insulation deterioration, electrical 
leakage or explosion which could result in fire.

Do not put your weight on this projector.
 

You could fall or the projector could break, and injury 
may result.

 

Be especially careful not to let young children stand 
or sit on the projector.

Disconnect the power plug from the wall outlet as a 
safety precaution before carrying out any cleaning.
 

Electric shocks can result if this is not done.

If the lamp has broken, ventilate the room 
immediately. Do not touch or bring your face close 
to the broken pieces.
 

Failure to observe this may cause the user to absorb 
the gas which was released when the lamp broke and 
which contains nearly the same amount of mercury 
as fluorescent lamps, and the broken pieces may 
cause injury.

 

If you believe that you have absorbed the gas or that 
the gas has got into your eyes or mouth, seek 
medical advice immediately.

 

Ask your dealer about the replacement of the lamp 
unit and check the inside of the projector.

Ask an Authorized Service Center to clean inside the 
projector at least once a year.
 

If dust is left to build up inside the projector without 
being cleaned out, it can result in fire or problems 
with operation.

 

It is a good idea to clean the inside of the projector 
before the season for humid weather arrives. Ask 
your nearest Authorized Service Center to clean the 
projector when required. Please discuss with the 
Authorized Service Center regarding cleaning costs.

Do not subject the projector to excessive vibration 
or shocks.
 

The projector lens need to be handled with care.

 

Cover the lens with the lens cover when transporting 
the projector.

When you move the projector, hold the body at the 
bottom securely.
 

Do not hold the adjuster legs or the leg adjuster 
buttons when move the projector, as this may cause 
damage.

When transporting, keep the projector in the 
provided carrying bag.
 

Make the lens of the projector upward direction and 
put it gently into the carrying bag.

 

In the carrying bag, the elongated adjuster legs must 
be housed.

 

Do not put anything other than the projector and its 
accessories in the carrying bag.