Panasonic PT-EZ770ZU User Manual
Chapter 6 Appendix — Technical information
ENGLISH - 145
r
Lens control command
Command
Sub command
Details
Remark
VXX
LNSI2
Lens H shift
+00000=Fine adjustment 1+, +00001=Fine adjustment 1-,
+00100=Fine adjustment 2+, +00101=Fine adjustment 2-,
+00200=Coarse adjustment+, +00201=Coarse adjustment-
VXX
LNSI3
Lens V shift
VXX
LNSI4
Lens focus
VXX
LNSI5
Lens zoom
<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote control
signals cannot reach.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.
Remote control
Contact control
Remote control/contact control
Standby
Lit
Lamp
RGB1
VIDEO
RGB2
HDMI
DVI-D
Installation locations in meeting rooms, etc.
Remote control board in another location
Pin assignments and signal names
D-Sub 9-pin
Outside view
Pin No.
Signal name
Open (H)
Short (L)
(9)
(6)
(5)
(1)
(1)
GND
―
GND
(2)
POWER
OFF
ON
(3)
RGB1
Other
RGB1
(4)
RGB2
Other
RGB2
(5)
VIDEO
Other
VIDEO
(6)
HDMI
Other
HDMI
(7)
DVI-D
Other
DVI-D
(8)
SHUTTER
OFF
ON
(9)
RST/SET
Controlled by remote
control
Controlled by external
contact
Attention
f
When controlling, make sure to short-circuit pins (1) and (9).
f
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g
Power <v/b> button on the control panel or the power on <b> button, power standby <v> button, and <SHUTTER> button on the remote
control
f
When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g
Power <v/b> button on the control panel or the power on <b> button, power standby <v> button, <RGB1/2> button, <DVI-D> button,
<VIDEO> button, <HDMI> button, <DIGITAL LINK> button, <DisplayPort> button, and <SHUTTER> button on the remote control
Note
f
For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (x page 94)