Panasonic PT-EZ580 PT-EW640 PT-EX610 PT-EW540 PT-EX510 User Manual
Chapter 4 Settings — [NETWORK] menu
108 - ENGLISH
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f
The projector does not support 10BaseT Full/Half.
When the projector is connected to a twisted-pair-cable transmitter
1) Press as to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
2) Press the <ENTER> button.
f
The
[DIGITAL LINK SETUP] screen is displayed.
3) Press as to select [DUPLEX(DIGITAL LINK)].
4) Press qw to switch the communication method.
4) Press qw to switch the communication method.
f
The items will switch each time you press the button.
[100BaseTX-Full]
Full-duplex communication method is set.
[100BaseTX-Half]
Half-duplex communication method is set.
[AUTONEGOTIATION]
The communication method is set automatically.
5) Press as to select [STORE].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
[DIGITAL LINK STATUS]
(Only for PT-EZ580, PT-EW640 and PT-EX610)
Display DIGITAL LINK connection environment.
Display DIGITAL LINK connection environment.
1) Press as to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
2) Press the <ENTER> button.
f
The
[DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS]
Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.
[HDCP STATUS]
Either [NO SIGNAL], [OFF], or [ON] is displayed.
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
MAX/MIN: Maximum/minimum value of the amount of error.
f
Green (-12 dB or lower) → Normal signal quality level.
f
Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced on the
screen.
f
Red (-7 dB or higher) → Abnormal level where synchronization may be interrupted or a signal may
not be received.
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1) Press as to select [NETWORK SETUP].
2) Press the <ENTER> button.
2) Press the <ENTER> button.
f
The
[NETWORK SETUP] screen is displayed.
3) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME]
Change the setting when using a DHCP server.
[DHCP]
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
[IP ADDRESS]
Enter the IP address when not using a DHCP server.