Panasonic PT-EZ580 PT-EW640 PT-EX610 PT-EW540 PT-EX510 User Manual
Chapter 4 Settings — [NETWORK] menu
ENGLISH - 111
f
For the LAN cable between a twisted-pair-cable transmitter and the projector, use a cable that meets the following criteria:
g
Compatible with CAT5e or higher
g
Shielded type (including connectors)
g
Straight-through
g
Single wire
f
The maximum transmission distance between the twisted-pair-cable transmitter and the projector is 100 m (328'1"). If this distance is
exceeded, image and sound may be disrupted and may cause a malfunction in LAN communication.
f
When laying cables between a twisted-pair-cable transmitter and the projector, check that cable characteristics are compatible with CAT5e
or higher using tools such as a cable tester or cable analyzer.
When using a relay connector midway, include it in the measurement.
When using a relay connector midway, include it in the measurement.
f
Do not use a hub between a twisted-pair-cable transmitter and the projector.
f
Do not pull cables forcefully. Also, do not bend or fold cables unnecessarily.
f
To reduce the effects of noise as much as possible, stretch out the cables between the twisted-pair-cable transmitter and the projector
without any loops.
f
Lay the cables between a twisted-pair-cable transmitter and the projector away from other cables, particularly power cables.
f
When installing multiple cables, run them side by side along the shortest distance possible without bundling them together.
f
After laying the cables, confirm that the value of [SIGNAL QUALITY] in the [NETWORK] menu → [DIGITAL LINK STATUS] is displayed in
green (indicates normal quality). (x page 108)
f
For twisted-pair-cable transmitter of other manufacturers of which the operation has been verified with the DIGITAL LINK compatible
projector, refer to Panasonic website (http://panasonic.net/avc/projector/). Note that the verification for devices of other manufacturers
has been made for the items set by Panasonic Corporation, and not all the operations have been verified. For operation or performance
problems caused by the devices of other manufacturers, contact the respective manufacturers.
Accessing from the web browser
1) Start up the web browser on the computer.
2) Enter the IP address set on the projector into the URL entry field of the web browser.
3) Enter the user name and the password.
2) Enter the IP address set on the projector into the URL entry field of the web browser.
3) Enter the user name and the password.
f
The factory default setting of the user name is user1 (user rights)/admin1 (administrator rights) and the password is panasonic (lower
case).
4) Click OK.
f
The [Projector status] page is displayed.
Note
f
If you use a web browser to control the projector, set [WEB CONTROL] to [ON] in [NETWORK CONTROL] (x page 109).