Panasonic PT-EZ580 PT-EW640 PT-EX610 PT-EW540 PT-EX510 User Manual

Chapter 3 Basic Operations — Switching on/off the projector

ENGLISH - 45

 

f

While the power indicator <ON (G)/STANDBY (R)> is lit in orange, the fan is running to cool the projector.

 

f

For about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators do not light up even if 

the power is switched on. After the power indicator <ON (G)/STANDBY (R)> lights in red, turn on the power again.

 

f

The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red). Refer to “Power consumption” 

(x page 149) for the power consumption.

 

f

The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.

 

f

The power indicator <ON (G)/STANDBY (R)> will flash slowly in green while the shutter is closed or AV mute function is used.

 

f

If the power indicator <ON (G)/STANDBY (R)> is flashing in red, consult your dealer.

When using the optional Projection Lens, attach the Projection Lens before switching on the projector.
Remove the lens cover first.

 

f

(AC 100 V - 240 V, 50 Hz/60 Hz)

 

f

After a short while, the power indicator <ON (G)/STANDBY (R)> will light in red, and the projector will enter the standby mode.

4)  Press the power <v/b> button on the control panel or the power on <b> button on the remote control.

 

f

The power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.

 

f

If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longer 

before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.

 

f

If the <MAIN POWER> switch was set to <OFF> during projection to end the projection using the direct power off function last time, and the 

<MAIN POWER> switch is set to <ON> with the power plug connected to the outlet, the power indicator <ON (G)/STANDBY (R)> will light in 

green and the image will soon be projected on the screen.

When the projector is switched on for the first time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu → 

[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Set them 

in accordance with circumstances.
In other occasions, you can change the settings by menu operations.

Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and shift.
Refer to “Adjusting the focus, zoom, and shift” (x page 49) for details.

1)  Press asqw to adjust the focus.