Panasonic TQBH9003-6 User Manual

B The batteries may be weak.
B The batteries may not be inserted correctly. (Refer to

B The remote control signal receptor on the projector may

B The remote control unit may be out of the operation

B Press and hold the Power button on the remote control

unit or the projector for more than 5 seconds to turn the
power off and back on again. At this time, the projector
will turn on and go to the standby condition.

B The CONTROL KEY may be set to “OFF”. (Refer to

In order to set the CONTROL KEY to “ON” without using
the remote control unit, keep holding down the ENTER
button on the projector and press the MENU button for
more than 2 seconds. It will then be turned ON.

B Press and hold the Power button on the remote control

unit or the projector for more than 5 seconds to turn the
power off and back on again. At this time, the projector
will turn on and go to the standby condition.

B The signal format (TV system) may not be set correctly.

B There may be a problem with the video tape or other

signal source.

B A signal which is not compatible with the projector may

B If you select SXGA60 or SXGA60+ type RGB signals,

the pictures may not be projected correctly. If this
happens, press the AUTO SETUP button.

B The cable may be too long.
B The external video output for the laptop computer may

not be set correctly.
(You may be able to change the external output settings
by pressing the [Fn]+[F3] or [Fn]+[F10] keys
simultaneously. The actual method varies depending on
the type of computer, so refer to the documentation
provided with your computer for further details.)

B If an RGB input indicator (Refer to page 

the video signals may not be output from the computer.

B RGB2 SELECT in the OPTION menu is set to OUTPUT

when the signals are input to RGB2 IN / RGB OUT
connector. (Refer to page